ViSound™ Drift is compatible with all Bluetooth-enabled devices, including iPhones, Android phones, iPads, and tablets.
Pairing takes just a few seconds — and once connected, your device will remember them automatically for next time.
📱 Quick Pairing Guide
Step 1: Take them out of the case
Your ViSound™ Drift earbuds will power on automatically and enter pairing mode.
You’ll see a flashing white light on both earbuds.
Step 2: Open Bluetooth settings on your phone
Go to:
Settings → Bluetooth → Enable Bluetooth (if not already on)
Step 3: Select “ViSound Drift” from the list
You’ll see “ViSound Drift” appear under available devices.
Tap it to connect.
Once paired, the flashing light will stop, and you’ll hear a confirmation tone.
🔁 They reconnect automatically
After the first setup, ViSound™ Drift will auto-connect to your phone or tablet as soon as you take them out of the case — no need to pair again each time.
📝 Notes
- If your earbuds don’t show up: Put them back in the case, close it for 10 seconds, then try again. You can also reset the earbuds by holding both touch panels for 8 seconds until the lights blink.
- ViSound™ Drift can only connect to one device at a time. If you want to switch from your phone to your tablet, disconnect from the first device first.
- Compatible with:
- iPhone & iPad (iOS 10 or later)
- Android (most versions supported)
- Tablets with Bluetooth
Need help? Our support team is here for you — just reach out!